Tips For Bending Laminate Around Radius Edges

Posted on 09 November 2012 by cradmin

Here is an insightful video by that offers a couple of tips when bending laminate around the radius edge of a countertop. We’d love to hear if others use this same method or if they have any other tips to offer.


3 Comments For This Post

  1. Marci Says:

    Thanks for the tips, we are always looking for ways to improve our laminate countertop shop!

  2. Karl Says:

    We prefer using a heat gun. It keeps the laminate thick and allows a smaller radius. With post-forming grade laminate you can do a radius of 1/2″.

  3. Joseph Corlett Says:

    On pieces where appearance doesn’t make a difference (solid colors as opposed to wood grains), make the “grain” on the back of the plastic laminate verticle instead of horizontal around the radius. It will bend much easier, but the length of your piece will be limited to the width of your sheet instead of the length.

Comment on this Post

Advertise Here

Photos from our Flickr stream

See all photos

Advertise Here

The Countertop Industry Insider


Subscribe to Get New Posts via Email

Enter your email address to join 185 of the best informed people in the industry who receive notifications of new posts by email. You can choose to receive notifications weekly or 1 per day, excluding weekends holidays.

Join 185 other subscribers

CountertopResource on Social Media


Also Check Out:

Professionals best place for info on green building